A new type of lifting induction melting furnace in 2020, which includes an induction melting furnace body 1, a flat bottom crucible 2, and also includes a refractory brick support 3, a motor and its transmission pulley 4, a lifting device 5, a connecting rod 6; an induction melting furnace There is a through hole in the bottom of the body l to the bottom of the flat-bottom crucible 2. The flat-bottom crucible 2 in the center of the induction melting furnace body 1 is placed on the refractory brick support 3 placed on the ground. 3 up and down; the motor and its transmission pulley 4 are connected to the lifting device 5 placed on the ground, the connecting rod 6-end is connected to the 5-side of the lifting device, and the other end is connected to the bottom plate of the induction melting furnace body 1. The other side of the lifting device 5 is connected to the balance weight 7 with another connecting rod 6. The lifting block of the lifting device 5 is a screw rotation balancing block. During operation, the lifting device 5 is controlled to raise the induction melting furnace body 1 to the top of the flat-bottom crucible 2 for charging and heating. During the operation, the use of the flat-bottom crucible 2 can be observed at all times. After the metal is completely melted, the lifting device 5 is controlled to melt the induction The furnace body 1 is lowered to the bottom of the flat-bottom crucible 2, and the flat-bottom crucible 2 is clamped by a special tool for casting operation.