Contact
Tel: 18037961302
Sales hot line ( 24 hours  service): 18037961302

E-Mail: firstfurnace@gmail.com

whatsapp:+8618037961302

Adress: Luoxin Industrial Park, Luoyang, Henan
  • Products
  • 0.25T Intermediate Frequency F

    0.5T Intermediate Frequency Fu

    Medium Frequency Furnace

    2T Induction Melting Furnace

    1T Induction Melting Furnace

    500kg Induction Melting Furnac

    250kg Induction Melting Furnac

    Induction Melting Furnace

    3 T Induction Melting Furnace

    5T Induction Melting Furnace

    1T One Belt Two Intermediate F

    5T One Belt Two Intermediate F

    3T One Belt Two Intermediate F

    2T One Belt Two Intermediate F

    5T Parallel Intermediate Frequ

    5T Intermediate Frequency Furn

    5T Series Intermediate Frequen

    3T Series Intermediate Frequen

    2T Series Intermediate Frequen

    1T Series Intermediate Frequen

    0.5T Series Intermediate Frequ

    0.25T Series Intermediate Freq

    1T Parallel Intermediate Frequ

    2T Parallel Intermediate Frequ

    0.5T Parallel Intermediate Fre

    0.25T Parallel Intermediate Fr

    Parallel Intermediate Frequenc

    3T Intermediate Frequency Furn

    Industrial electric furnace technical information
        

    1. The installation of the 1 ton intermediate frequency furnace shall be carried out according to the floor plan and the basic drawing.

    2. After installation, first check whether the grounding of the hob is good, and the grounding resistance should be less than 4Ω.

    3. Check the insulation resistance between the conductive plates of the inductor and the metal parts of the furnace before passing through the water: measured with a 2500V megger, it should be greater than 2MΩ.

    4. Connect the cooling water into and out of the water pipe and set the electric contact pressure gauge to 0.2Mpa.

    5. Check that the direction of rotation of the oil pump motor is the same as the direction of rotation of the oil pump and connect the hydraulic system piping.

    6. Tilt the furnace body, check whether the hydraulic 1 ton intermediate frequency furnace is in good condition, and whether the seals and pipeline joints leak oil.

    7. The no-load power is supplied to the inductor, and the voltage is from low to high until the rated value, and the vibration of the component and the inductor is checked.

    8. After the above checks are correct, the lining can be built by hanging the dies.

    9. Tanning and sintering points of the lining: (Refer to the quartz sand lining)

    9.1 . After the induction furnace is installed and tested, the lining and sintering lining can be started . The smelting and sintering of the lining is the key to determining its life and safe operation. The operating procedures should be strictly observed.

    9 .2. Requirements for lining materials:

    The acid furnace lining sintered by quartz sand should be pure (sio 2 >98.5」99.5%), no other inclusions, should be hand-selected, magnetically selected, sieved, and then subjected to 5-6 h at 180-200 <C. Honggan.


    Copyright© 2007-2013 songdao Electric furnace manufacturing Co,.Ltd All Rights Reserved
    Tel:18037961302 Sales hot line ( 24 hours service): 18037961302
    E-Mail:firstfurnace@gmail.com
    Adress: Luoxin Industrial Park, Luoyang, Henan